The Current Transformers are designed for easy installation with a simple, fast, safe and easy way to connect a monitoring system to your power supply.

• Sensing Overload Currents
• Ground fault detection
• Metering
• Analog to Digital circuits
• Facilities and building management

They are split-core current transformers that can be installed without opening any cable or bus bar circuit. The connection of conventional Current Transformers (CTs) usually requires the interruption of the primary side circuit to pass cables or bus bars through the transformer core or to connect such cables to the primary terminals.

This Current Transformer connects to the securityProbe and has its interface so you can set parameters for monitoring and alerting on a variety of measurement factors.

The E-sensor8 is an expansion module that has 8 RJ-45 intelligent sensor ports and is connected to any of the 4 RJ-45 expansion ports located on the front panel of the securityProbe 5ES base units. They are connected using standard CAT5 LAN cable. The E-Sensor8 may also be daisy chained using the E-Out/E-In ports on other expansion boards.

Any sensor within our complete line of intelligent sensors can be connected to the intelligent sensor ports which are located on the rear of the unit. 16 LED’s on the front provide each sensors visual condition, 8x red for status and 8x green for online.
The expansion boards can be daisy chained together using the units input, or E-in and output, E-out port. These also are RJ-45 ports and use standard CAT5 cable.

These E-Boards can be extended from the securityProbe 5Es base unit or from each other up to 300 meters, or roughly 1000 feet.

This Power Monitor Sensor gives vital information and allows you to remotely monitor power eliminating the need for manual power audits as well as providing immediate alerts to potential problems. This Power Monitor Sensor is specifically designed to be used with our sensorProbe+ and securityProbe base units.

It has been integrated into the sensorProbe+ and securityProbe’s web interface with its own “Power Management” menu, allowing multiple three-phase and single-phase Power Monitor Sensors to be set up on a single sensorProbe+ or securityProbe depending on which readings are required.

Data collected over time using the Power Monitor sensor can also be viewed using the built-in graphing tool.

Combining this durable Power Monitor Sensor with the sensorProbe+ and securityProbe creates an IP-enabled power monitoring capable of monitoring/measuring:

• Phase Line Voltages
• Current
• Power Factor
• Active Energy
• Active Power

Note: Installation should be performed by licensed electricians familiar with applicable codes and regulations.